04-22-2010 02:40 AM - edited 03-06-2019 10:44 AM
Hello
I'm going to start the evaluation of implementing the virtualization of our campus LAN using MPLS.
We'll get many inter-VLAN routing domains per VRF on the same LAN infrastructure.
The LAN infrastructure is based on C6500 implementing VSS.
Do you have experience with this kind of setup?
Any known/faced issue that might prevent the setup of MPLS on VSS enabled C6500?
Thank you
Best regards,
Andrea
04-22-2010 02:50 AM
Hello Andrea,
>> Any known/faced issue that might prevent the setup of MPLS on VSS enabled C6500?
you will need 12.2(33)SXI2 or later to have MPLS support
VSS best practices
http://www.cisco.com/en/US/products/ps9336/products_tech_note09186a0080a7c837.shtml
Hope to help
Giuseppe
04-22-2010 02:59 AM
>> you will need 12.2(33)SXI2 or later to have MPLS support
Yes, that's already covered. thanks
>> VSS best practices http://www.cisco.com/en/US/products/ps9336/products_tech_note09186a0080a7c837.shtml
The document does no address the implementation of VRFs. It's just a light guide on the implementation of VSS.
Thanks in any case for the reply.
Andrea
04-22-2010 03:21 AM
Hello,
you can start from here
Hope to help
Giuseppe
11-12-2011 08:22 PM
I am planning to run VSS on a dual PE as well.
I cant find any related configuration docs for this.
any idea?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: