Hairpinning and remote vpn access

Unanswered Question
Jennifer Halim Fri, 04/23/2010 - 03:48
User Badges:
  • Cisco Employee,

Shouldn't be a problem.

If you have split tunnel configured, you would also need to add the vpn ip pool subnet in the split tunnel ACL.

If it's ASA firewall, then you would need to configure "same-security-traffic permit intra-interface"

Other than that, the remote access vpn should be able to access each other via the vpn assigned ip address.

Jennifer Halim Fri, 04/23/2010 - 05:34
User Badges:
  • Cisco Employee,

Can't find any sample configuration on site.

If you configure the advised configuration and it still doesn't work, feel free to post your config, and I can check out what might be missing.


This Discussion