04-23-2010 03:02 AM
Hi all,
I would like to know if it is possible to set up hairpinning to allow users connected to the same site through a remote access VPN to communicate between themselves, but also with the site itself.
Does anyone have configure that kind of thing?
Rgds
jr
04-23-2010 03:48 AM
Shouldn't be a problem.
If you have split tunnel configured, you would also need to add the vpn ip pool subnet in the split tunnel ACL.
If it's ASA firewall, then you would need to configure "same-security-traffic permit intra-interface"
Other than that, the remote access vpn should be able to access each other via the vpn assigned ip address.
04-23-2010 04:46 AM
Thanks for your replys.
Do you know where I should find some documentation concerning that kind of configuration?
Rgds,
jr
04-23-2010 05:34 AM
Can't find any sample configuration on cisco.com site.
If you configure the advised configuration and it still doesn't work, feel free to post your config, and I can check out what might be missing.
04-23-2010 05:36 AM
OK. Thanks for your help. I will try your idea.
Rgds,
jr
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: