04-23-2010 07:59 AM - edited 03-06-2019 10:46 AM
Hello,
I've a stack with 3 Catalyst WS-C3750G-24TS-S1U with IP Base software image.
Now I need to use PBR and so I need to upgrade to IP Service image.
I need to buy an upgrade for each member of the stack? Or I can buy just an upgrade for all the stack?
Then... just for confirm: the rule that I need to use is very simple, I have a routing table with some routes on 192.168.xx and 10.xxx and a default gateway at 192.168.2.110 that we use for internet browsing.
I would like that some hosts use another default gateway instead, and then I've thinked to set a policy like this:
ip access-list extended to201
deny ip any 192.168.0.0 0.0.255.255 deny ip any 10.0.0.0 0.255.255.255 permit ip 192.168.2.0 0.0.0.255 any deny ip any any
!
route-map switchugw permit 10match ip address to201
set ip next-hop 192.168.2.201
!
!
Interface Vlan 2
ip policy route-map switchugw
There is a way to do this with the feature of the ipbase?
thanks
Solved! Go to Solution.
04-26-2010 12:20 PM
I need to buy an upgrade for each member of the stack?
Yes
Or I can buy just an upgrade for all the stack?
No, each switch is treated as a separate entity in term of hardware and software support and licenses.
Regards
Edison
04-26-2010 12:20 PM
I need to buy an upgrade for each member of the stack?
Yes
Or I can buy just an upgrade for all the stack?
No, each switch is treated as a separate entity in term of hardware and software support and licenses.
Regards
Edison
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide