Same aggregate policer applied to different policy-map under different class

Unanswered Question
Apr 23rd, 2010

In Cisco 7600, I created a named aggregate policer: AGGRE. Then I call the same aggregate policer from 2 different policy-map (POLICE-2 and POLICE-3) using the police aggregate command. Note that in each policy-map, the aggregte policer is called under different class: CLASS-2 and CLASS-3. Finally I applied POLICE-2 and POLICE-3 to vlan 2 and vlan 3. Will the aggregate policer work on the aggregation of traffic from both VLAN 2 and 3? Or will it just work independantly on either vlan?

mls qos aggregate-policer AGGRE ...

class CLASS-2

match access-group ACL2

class CLASS-3

match access-group ACL3

policy-map POLICE-2

  class CLASS-2

  police aggregate AGGRE

policy-map POLICE-3

  class CLASS-3
  police aggregate AGGRE


interface Vlan2
service-policy output POLICE-2

interface Vlan3
service-policy output POLICE-3

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content