Unity Connection Cluster - DNS resolution

Unanswered Question
Apr 23rd, 2010

It is posible to remove DNS resolution in a cluster AFTER the cluster is set (AKA: both unity Connection were installed using DNS resolution)?

Version 7.1

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
David Hailey Fri, 04/23/2010 - 16:48

The installation rules for DNS are that if you do not configure it on initial install, then you cannot enable it post-installation without rebuilding the system.  My inclination is that the reverse is also true.  I also tested trying to remove the DNS configurations on a 7.1(3b)SU1 CUC server in my lab and there doesn't appear to be a valid command to do this.  You can change the primary and secondary DNS servers; however, you cannot disable DNS.

Hailey

Please rate helpful posts!

aalejo Fri, 04/23/2010 - 18:33

Hi

If you take out the DNS server(s)s you will disable DNS resolution.

- Alex

David Hailey Fri, 04/23/2010 - 18:38

Alex,

Have you attempted to do this on a 7.1 server? If you attempt to set a blank DNS server, you get a CLI error for a missing, required configuration parameter...at least I did.

Hailey

Actions

This Discussion