04-24-2010 08:19 AM - edited 03-15-2019 10:27 PM
Hi All,
I need to make bonding"teaming" on CUCM 6.1 based on Linux based.
How I can do it?
How I can show bonding status?
I know from CLI i can type "show network failover".Can i show it from OS administration web page?
BR,
Ahmed Kamal
04-24-2010 08:32 AM
The command to enable it is set network failover enable
However the two NICs will work in active/standby mode. Having both NICs active as an EtherChannel is not supported.
It is not possible to view or enable the setting from the web page.
04-24-2010 08:34 AM
As James said, the NIC failover is for redundancy/failover (active/passive) only. It is NOT NIC teaming which is a completely different concept. It can only be enabled via CLI.
Hailey
Please rate helpful posts!
04-24-2010 09:52 AM
Actuaslly i am little confused.
When I run "show network failover" i got bonding correct.
BUT when i go to OS administration------>show------->network I got nothing related to bonding.
Is that normal?
How can i display my bonding settings from GUI also?
04-24-2010 11:22 AM
Youssef, there isn't really anything to be confused about my friend. The network failover commands are CLI-based only. You don't see the status from the GUI, this is normal. What you can see from GUI is not always equal to what you can see from CLI.
Hailey
Please rate helpful posts!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide