Invisible Route Pattern

Answered Question
Apr 26th, 2010
User Badges:

This one has me stumped!!


I have a building that needed an interface to overhead paging, so I used an ATA186 and wired into the paging system that way.  Users must pick up the phone and dial *1 to overhead page.  So my problem here is I would like to check this setup against another building I am trying to do the same thing in.  In CCM 4.1(3) I can find nothing under Route Patterns for *1.  The 2801 at the site is H323, again, nothing in the config under translation patterns for *1, and the 3560 that has the ATA of course has nothing for *1.  Yet it works, LOL!!!  Where would I find the *1 pattern and how it is setup?  This is so weird!


Thanks anyone.

Correct Answer by chris.warren about 7 years 2 months ago

is it possilbe that it is a translation pattern? Check the Route Plan Report for anything starting with *1.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
chris.warren Mon, 04/26/2010 - 06:20
User Badges:

is it possilbe that it is a translation pattern? Check the Route Plan Report for anything starting with *1.

townofnewmarket Mon, 04/26/2010 - 06:27
User Badges:

Thanks, that helped.  It was installed as a Directory Number.

Not sure of the benefit of that, but hey it works!

Actions

This Discussion