Access Point GUI issue with MAC auth

Unanswered Question
Apr 27th, 2010
User Badges:

I have few Autonomous Access Points all managed by GUI.


Users have access to wireless network based on MAC authentication & Encryption password. Occasionally the wireless access to the Access-Point fails and the following errors is show in the GUI.


ERROR: The MAC address filter 700 used for association access was not created by the web interface and cannot be displayed. (snapshot attached)

WARNING: Filter 700 was configured on interface Dot11radio 0.170 using CLI. It must be cleared via CLI to ensure proper operation of the web interface.


The Network Admin does not use CLI to manage but this problem still happens.


To fix this problem I had cleared the access-list 700 via CLI and created a new access-list 700 via Cisco Network Assistant. Adding all the MAC's each time the network goes down is a cumbersome process. Is there a solution for this?


Thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jaider.junior Fri, 10/01/2010 - 06:48
User Badges:

Dear Mr. jennyjohn,



I had the same problem, and the solution was restart the Access Point before anything else.






Graciously,
Jaider Xavier Júnior

Fox Minas Construct - Porto Velho - Brazil

Actions

This Discussion