I was trying to do the selection of outgoing FXO port based on ANI address, I was going through some of the posts https://supportforums.cisco.com/message/383216#383216 also cisco document on this. My issue is call from the CCM is not hiting this perticular VOIP peer, Do i need to do anything in the CCM to make the call to hit this newly created VOIP peer so that it can see the ANI and apply the translation rules.
Steps were :
dial-p v 1 voip
translation-profile (adds a 955 to beginning of called number)
dial-p v 2 voip
translation-profile (adds a 966 to beginning of called number)
dial-p v 3 pots
dial-p v 4 pots
Created translation profile also.