Cisco PIX 515 connect to redundant switches

Unanswered Question

I have redundent switchs on my internal network where a server plugs into each switch so that if a port goes down, bad cable, bad switch, connectivity remains.  I have a 4-port ethernet module on my PIX and was wondering if that could tie into each switch with spanning tree to increase my redundancy.  This way if a switch dies, I do not have to physically move the cable to another switch.  If this is possible, does anyone have any examples on how to configure it?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion