cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
416
Views
0
Helpful
1
Replies

Cisco PIX 515 connect to redundant switches

ngthen
Level 1
Level 1

I have redundent switchs on my internal network where a server plugs into each switch so that if a port goes down, bad cable, bad switch, connectivity remains.  I have a 4-port ethernet module on my PIX and was wondering if that could tie into each switch with spanning tree to increase my redundancy.  This way if a switch dies, I do not have to physically move the cable to another switch.  If this is possible, does anyone have any examples on how to configure it?

1 Reply 1

Jennifer Halim
Cisco Employee
Cisco Employee

You can configure redundant interface from version 8.0.2 onwards.

Here is the sample configuration for your reference:

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/intrface.html#wp1045838

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: