VIC2-2FXS at Cisco 2811 ISR, is NM-HDV2 needed?

Answered Question
Apr 28th, 2010

Hello,

I have a Cisco 2811 router that is configured as CUCME and working OK. So I need to connect a fax machine so I decided to take FXS card, but I don't know if I need to find NM-HDV2 to get VIC2-2FXS working on 2811, or it works at any of HWIC slots... I have FXO (VIC2-4FXO) working w/o any network module (installed at HWIC slot), so do I need such for FXS?

P.S.: I have PVDM2-8 installed in the router, will it be enough?

Thank you.

I have this problem too.
0 votes
Correct Answer by Paolo Bevilacqua about 6 years 7 months ago

The NM is not needed.

The PVDM that you have is enough.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.

Actions

This Discussion

Related Content