cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1060
Views
3
Helpful
3
Replies

C6509, FWSM Failover, C3560G, Vlans

ioan_ploscariu
Level 1
Level 1

Hi,

I have the folowing network scenario:

In the central node:

   1 Catalyst 6509

   2 FWSM (failover and routed mode configured)

In the remote locations:

    1 Catalyst 3560G

I want to have more than one vlans behind catalyst 3560G switches.

How i configure the firewall and the routing between FWSM and C3560G?

Scenario is presented in the attached draft (tested for one vlan).

Thank you.

3 Replies 3

Jon Marshall
Hall of Fame
Hall of Fame

ioan_ploscariu wrote:

Hi,

I have the folowing network scenario:

In the central node:

   1 Catalyst 6509

   2 FWSM (failover and routed mode configured)

In the remote locations:

    1 Catalyst 3560G

I want to have more than one vlans behind catalyst 3560G switches.

How i configure the firewall and the routing between FWSM and C3560G?

Scenario is presented in the attached draft (tested for one vlan).

Thank you.

Not sure what your query is ?

Is the 3560G routing the vlans or are they meant to be routed on the FWSM ?

Jon

I want the FWSM to make NAT for vlans even if one firewall module failed and the PC behind switches  to have internet access through firewall module.

How i configure the firewalls and the switches to make this happen?

Thank you.

I want the FWSM to make NAT for vlans even if one firewall module failed and the PC behind switches  to have internet access through firewall module.

How i configure the firewalls and the switches to make this happen?

Thank you.

Hi ,

For above requirement create a trunk configuration between 3560G and 6509 switch and push those vlans into FWSM,Drop the gateways of the pc to FWSM vlan interface and drop a reverse route for vlan subnet towards the switch side.

For failover configuration on FWSM Active/passive check out the below link

http://www.cisco.com/en/US/docs/security/fwsm/fwsm32/asdm52f/user/guide/switch.pdf

For natting configuration in FWSM check out the below link

http://www.cisco.com/en/US/docs/security/fwsm/fwsm22/configuration/guide/quick.html

Hope to help !!

Ganesh.H

Remember to rate the helpful post

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: