Cisco CUCM 7 e&m conference

Unanswered Question
Apr 30th, 2010
User Badges:

I would like to configure a e&m port on a 2811 so that my users can dial into it.


In the past I have made it work on a one to one basis.


I would like more than than user to be able to dial in at any time.


I assume I need  to set it up as a h.323 gateway, but how do I get the "conference" functionality

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
stowellp Fri, 04/30/2010 - 04:47
User Badges:
  • Bronze, 100 points or more

Hi Martin,


Gateway needs to be configured as H323

To enable an analogue port to be able to use conferencing it needs to be controlled via SCCP as below


stcapp ccm-group 1
stcapp


dial-peer voice xx pots
description **Dial Peer for Main Conference Phone**
service stcapp
port x/x/x


ephone-dn  XX  dual-line
number XXX
label Main Conf Room
transfer-mode consult


ephone  xx
mac-address xxxx.xxxx.xxxx
max-calls-per-button 2
type anl
button  1:xx



Cheers,

Phil

Actions

This Discussion