Hi Netpro,
Voice messages can be correctly left in the voice mailbox, but MWI cannot reach phones. I have tried all three ways of delivering MWI with no success.
CME is SIP trunking to a SIP proxy server for PSTN calls. This part is working fine.
From CUE debugs, I can see the CUE is sending the MWI SIP messages to the CME; but no debug messages appear in CME (with 'debug ccsip all' and 'debug voice dialpeer all'). So the WMI does not reach CME.
Is this a bug? Any ideas?
=====================================cme config
IOS=====uc500-advipservicesk9-mz.124-11.XW6
interface Loopback0
ip address 10.1.10.2 255.255.255.252
ip virtual-reassembly
!
interface Integrated-Service-Engine0/0
ip unnumbered Loopback0
ip virtual-reassembly
service-module ip address 10.1.10.1 255.255.255.252
service-module ip default-gateway 10.1.10.2
!
dial-peer voice 2000 voip
description ** cue voicemail pilot number **
answer-address 1099
destination-pattern 1099
b2bua
session protocol sipv2
session target ipv4:10.1.10.1
incoming called-number 88[89]....
dtmf-relay sip-notify
codec g711ulaw
no vad
!
ephone-dn 159
number 888....
mwi off
!
!
ephone-dn 160
number 889....
mwi on
!
=======================================================================cue config
UC500-CUE# sh software ver
Installed Packages:
Software Version: 3.0.3
UC500-CUE# sh ccn su sip
SIP Gateway: 10.1.10.2
SIP Port Number: 5060
DTMF Relay: sip-notify,sub-notify
MWI Notification: outcall
Transfer Mode: bye-also
SIP RFC Compliance: Pre-RFC3261
---------------------------------------------
UC500-CUE# sh ccn app
Name: ciscomwiapplication
Description: ciscomwiapplication
Application type: aa
Script: setmwi.aef
ID number: 0
Enabled: yes
Maximum number of sessions: 6
CallControlGroupID: 0
strMWI_OFF_DN: 888
strMWI_ON_DN: 889
---------------------------------------------------
UC500-CUE# no trace all
UC500-CUE# trace ccn StackSip DBUG
UC500-CUE# clear tra
UC500-CUE# mwi refresh telephonenumber 1400
UC500-CUE# sh trace buff lo
Press <CTRL-C> to exit...
3395 05/01 15:47:11.309 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTINGenter connect
3395 05/01 15:47:11.309 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTINGenter createInvitation
3395 05/01 15:47:11.309 ACCN SIPL 0 SDPBody : v=0
o=CiscoSystemsSIP-Workflow-App-UserAgent 2253 2253 IN IP4 10.1.10.1
s=SIP Call
c=IN IP4 10.1.10.1
t=0 0
m=audio 16908 RTP/AVP 0
a=rtpmap:0 pcmu/8000
a=ptime:20
3395 05/01 15:47:11.311 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTINGbefore invitationmanager.createInvitation. body : v=0
o=CiscoSystemsSIP-Workflow-App-UserAgent 2253 2253 IN IP4 10.1.10.1
s=SIP Call
c=IN IP4 10.1.10.1
t=0 0
m=audio 16908 RTP/AVP 0
a=rtpmap:0 pcmu/8000
a=ptime:20
body type : application/sdp toNA : <sip:8891400@10.1.10.2:5060;user=phone> fromNA : <sip:1099@10.1.10.1:5060> from tag : cuef594fbb8
3395 05/01 15:47:11.311 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTINGafter invitationmanager.createInvitation
3395 05/01 15:47:11.312 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTING added ciscogcid
3395 05/01 15:47:11.312 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTING getDTMFHeader: Enter
3395 05/01 15:47:11.312 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTING getDTMFHeader: getting the headers
3395 05/01 15:47:11.312 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTING getDTMFHeader: before adding headers to message
3395 05/01 15:47:11.313 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTING getDTMFHeader: after adding headers to message :
INVITE sip:8891400@10.1.10.2:5060;user=phone SIP/2.0
Via: SIP/2.0/UDP 10.1.10.1:5060;branch=z9hG4bKooUjPgeVHhJTOspwHd2EGA~~8
Max-Forwards: 70
To: <sip:8891400@10.1.10.2:5060;user=phone>
From: <sip:1099@10.1.10.1:5060>;tag=cuef594fbb8
Call-ID: 127268203130711@10.1.10.1
CSeq: 1 INVITE
Content-Length: 172
Contact: <sip:1099@10.1.10.1:5060>
Content-Type: application/sdp
Cisco-Gcid: 51C2A8CB-0128-1000-4000-001125CUCE68
Call-Info: <sip:10.1.10.1:5060>;method="NOTIFY;Event=telephone-event;Duration=2000"
Allow-Events: telephone-event
v=0
o=CiscoSystemsSIP-Workflow-App-UserAgent 2253 2253 IN IP4 10.1.10.1
s=SIP Call
c=IN IP4 10.1.10.1
t=0 0
m=audio 16908 RTP/AVP 0
a=rtpmap:0 pcmu/8000
a=ptime:20
3395 05/01 15:47:11.314 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTINGinvite message : INVITE sip:8891400@10.1.10.2:5060;user=phone SIP/2.0
Via: SIP/2.0/UDP 10.1.10.1:5060;branch=z9hG4bKooUjPgeVHhJTOspwHd2EGA~~8
Max-Forwards: 70
To: <sip:8891400@10.1.10.2:5060;user=phone>
From: <sip:1099@10.1.10.1:5060>;tag=cuef594fbb8
Call-ID: 127268203130711@10.1.10.1
CSeq: 1 INVITE
Content-Length: 172
Contact: <sip:1099@10.1.10.1:5060>
Content-Type: application/sdp
Cisco-Gcid: 51C2A8CB-0128-1000-4000-001125CUCE68
Call-Info: <sip:10.1.10.1:5060>;method="NOTIFY;Event=telephone-event;Duration=2000"
Allow-Events: telephone-event
v=0
o=CiscoSystemsSIP-Workflow-App-UserAgent 2253 2253 IN IP4 10.1.10.1
s=SIP Call
c=IN IP4 10.1.10.1
t=0 0
m=audio 16908 RTP/AVP 0
a=rtpmap:0 pcmu/8000
a=ptime:20
3395 05/01 15:47:11.315 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTINGreturning invitation
3395 05/01 15:47:11.315 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTINGgot Invitation
3395 05/01 15:47:11.315 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTINGbefore Invitation start
3395 05/01 15:47:11.320 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTINGafter Invitation start
3395 05/01 15:47:16.310 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTING terminating dialog in contacting state 20
3395 05/01 15:47:16.310 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTINGcontacting state hangup
3395 05/01 15:47:16.310 ACCN SIPL 0 sip-ltp7: 1099, State=CONTACTINGAfter contacting state hangup
Thanks in advance.
