cme help please

Answered Question
May 1st, 2010

Hi Expert..

I just wondering, if I have the topology below.... So, if RouterC would like to call RouterA.. how RouterB forward RouterC call to RouterA?

Is there any features or options should I use?

And in this topology, eigrp is involve (I can ping the host on RouterA from RouterC but I cannot ring the ip phone on RouterA)

RouterA---------------RouterB---------------RouterC

     |                                |                                     |

     |                                |                                     |

Ip phone 2000       IP ph 2001                IP ph 2002

Thanks in advance

I have this problem too.
0 votes
Correct Answer by david-lima about 6 years 7 months ago

Hi Terrence, first in your router C you should have two  voip dial-peers; one pointing to the router A and the other one pointing to the router B.

Router C

dial-peer voice 10 voip

descrription ToRouterA

destination-pattern 1...

sesion target ipv4:IP CME Router A

------

dial-peer voice 20 voip

descrription ToRouterB

destination-pattern 2...

sesion target ipv4:IP CME Router B

------

Share your config if is possible .

hth

Change the destination-pattern as your needs.

David

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
david-lima Sat, 05/01/2010 - 18:16

Hi Terrence, first in your router C you should have two  voip dial-peers; one pointing to the router A and the other one pointing to the router B.

Router C

dial-peer voice 10 voip

descrription ToRouterA

destination-pattern 1...

sesion target ipv4:IP CME Router A

------

dial-peer voice 20 voip

descrription ToRouterB

destination-pattern 2...

sesion target ipv4:IP CME Router B

------

Share your config if is possible .

hth

Change the destination-pattern as your needs.

David

Actions

This Discussion