I'm very new with Cisco devices. I have a Cisco router 851 Wireless and i configured it manually (a simple local network with a Wan interface for internet).
I'm trying now to add a Wpa wireless to terminate my wanted configuration.
I'm using the new Cisco Configuration Professional 2.1 (the thick interface on my laptop and the Express one on the router).
I watched 2 screens casts ( http://www.cisco.com/en/US/docs/net_mgmt/cisco_configuration_professional/scrcst/ccpsc.html -> "Configuring the Wireless Feature on Routers with Dot11 Radio Interface" & "Configuring a Wireless Network with WPA Personal Security Enabled " ).
Basically, theses screens casts show how to access the basic graphical interface to simply add a wireless network ( see the screenshot in attachment).
Then I got the following error message : "No more than -1 SSIDs can be configured for Dot11Radio0 interface".
It is strange for me because my configuration is quiet basic and I didn't touch the Dot11Radio0 interface yet.
The other wireless application link (in the bottom of the screenshot) is too complex for me and I'd like to add my wireless network through the basic interface of Cisco CP 2.1 and see the CLI commands.
Here is some information's about my router (if more info is needed, please let me know)
Cisco IOS Software, C850 Software (C850-ADVSECURITYK9-M), Version 12.4(4)T7, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Wed 29-Nov-06 00:37 by kellythw
ROM: System Bootstrap, Version 12.3(8r)YI3, RELEASE SOFTWARE
GregCisco851W uptime is 1 hour, 45 minutes
System returned to ROM by reload
System image file is "flash:c850-advsecurityk9-mz.124-4.T7.bin"
Cisco 851W (MPC8272) processor (revision 0x200) with 59392K/6144K bytes of memory.
Processor board ID FCZ111024RV
MPC8272 CPU Rev: Part Number 0xC, Mask Number 0x10
5 FastEthernet interfaces
1 802.11 Radio
128K bytes of non-volatile configuration memory.
20480K bytes of processor board System flash (Intel Strataflash)
Configuration register is 0x2102
Thanks in advance
I checked with the IOS version you are using and I see the same error too. Some of the CLIs have changed since
124(15)T and CCP supports newer versions of the CLI. I verified that Add wireless networks worked fine with
124.(15)T7 which I downloaded from cisco.com.
Pls do keep me posted on the progress.
I found out that Cisco Configuration Professional -> Add wireless network is not supported on the particular IOS image you are using. You need the IOS version to be 124-15.T or above. Could you pls try after upgrading the IOS image pls?