I have a LAC for pppoerelay session from my customer. I have an LNS that terminate L2TP tunnel and for the authentication of customer. This configuration works.
Now, I would like to do a 'service selection' based on the domain in the username.
So I change my configuration and add "domain" in "vpdn-group" (see below) in the LAC.
The question is that this command is ignored and I can pass using different domains.
This is my LAC configuration:
subscriber profile gianrico
service relay pppoe vpdn group miovpngroup
domain mydomain.org <-- It seems that this is ignored in this specific configuration (pppoerelay I mean)
initiate-to ip 192.168.100.1
l2tp tunnel password 0 mypassword
bba-group pppoe MYPPPOEGROUP
service profile gianrico
description --- WAN SIDE ---
ip address 192.168.100.12 255.255.255.0
description --- customer side ---
ip address 192.168.40.2 255.255.255.0
pppoe enable group MYPPPOEGROUP
ip unnumbered FastEthernet0/0
ppp authentication pap chap
ppp chap hostname myhostname