cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
472
Views
5
Helpful
3
Replies

WLC 4402

alsayed
Level 1
Level 1

Hello

I have 30 access points with 2 WLC 4402 each one connected to 6506 by just 1 link,as 4402 support 25 access points ,what can i do in this situation?

1)do i assign 15 access point to each WLC?e.g 15 LWAP per controller?or what?

2) is it recomnded to ulize both gig interface on the WLC?e,g 1 interface to each 6506?

3)or assign the 30 LWAP to 1 controller and keep the 2nd standby?

what is ur recomdation in this situations

Thanks a lot experts

3 Replies 3

Leo Laohoo
Hall of Fame
Hall of Fame

do i assign 15 access point to each WLC?e.g 15 LWAP per controller?or what?

Whatever floats your boat.  If I was in the same situation as you, I'd have 15 LAPs go to one controller and the other 15 to another.  I would also configure the backup WLC as well.

2) is it recomnded to ulize both gig interface on the WLC?e,g 1 interface to each 6506?

It would be nice but not necessary.  Cisco recommend no more than 25 APs "tied" to one distribution ports due to bandwidth constraints.  Since you have a 4402-25 I don't see any need unless you have extra SFPs available.

Hope this helps.  Don't forget to rate our posts.

thanks lelyahoo?any new update on ur webpage?

Plz explain this:

I would also configure the backup WLC as well.

any new update on ur webpage?

MY webpage????

I would also configure the backup WLC as well.

WLC1 to be configured as "primary" and WLC2 as "secondary" to the APs joined to WLC1. 
For APs joined to WLC2, configure WLC2 as "primary" and WLC1 as "secondary".

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: