Jon Marshall Tue, 05/04/2010 - 09:52
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Answered in Lan Routing and Switching.


Jon

George Stefanick Tue, 05/04/2010 - 21:16
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, October 2015

The switchport nonegotiate command is used to stop the port from sending DTP messages (Dynamic Trunk Port).... if you have an access port that you dont want ti turn into a trunk ....

Alessio Andreoli Thu, 07/19/2012 - 04:56
User Badges:
  • Silver, 250 points or more

Hi there,

static access or the more familiar:


int fa0/1

switchport mode access

switchport access vlan vlan_number

no shut

end

!


is the last state of the DTP negotiation. When all the DTP negotiations to be a trunk fail, then you fall back in the static access mode where just one vlan can cross the link.  For the use itself of the command read George above


If you are working on HA environments use this command!!!


Alessio

Actions

This Discussion