Verifying the QOS by Reserving bandwidth to a PC

Unanswered Question
May 4th, 2010


I need to limit bandwidth or Reserver bandwidth for a network, Eg:Iam having 1Mbps connection and there are two vlans


128 is for Voice

128 for Web

256 for  data


Network B

256 for Voice in this network

256 for data in this networkB

.So any network can use only the specified bandwidth as maximum  irrespective of congestion in the network or not.

I thought to use "Bandwidth" command to reserver required bandwidth for each network.But i read in documents that Bandwidth which is specifiedunder this command is used only when there is congestion.

Iam not able to use Rate-limit becuase i need to classify different traffic in NetworkA and reserver BW for each

How i can achieve this?

For testing i configured QOS for a specific PC by reserving only very less Bandwith using Police command but

Download and Upload speed is same Before QOS applied to WAN interface and after QOS applied.(that too speed is maximum)

Iam testing using in browser

Is my Testing is Right?

Why iam not getting limited Bw

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Hitesh Vinzoda Fri, 05/14/2010 - 06:01

try downloading a file from web and limit your PC to use http traffic for x amount of low bandwidth. than try


Hitesh Vinzoda


This Discussion