Can you help me to provide information where i can find the BOM (Bill of Materials) for the switch with following specs ?
• Two core switches are required for redundancy on the architecture level.
• Every switch shall be fully redundant in power supplies and supervisor engines.
e Core switches are used to build a collapsed core layer which is responsible for routing
functions, aggregating 10 Gig uplinks from access layer and hosting servers.
10 GE ports shall be equipped with original X2 interfaces from same manufacturer of the
• Each of the two core switches should meet the following minimum specs:
o Rack mount Modular chassis with a minimum of 1 free slot after installing all modular
o Must have passive backplane architecture.
o Must be configured with redundant power supplies.
o Must be configured with a supervisory or control module and minimum 512MB RAM
expandable to 1GB.
o Must have a minimum redundant switching capacity of 720Gbps.
o The supervisory module must have at least two 10 Gigabit Ethernet ports equipped
with two SR X2 modules.
o Must be configured with (1) one 4-port 10Gigabit Ethernet modules fully populated
with the correct type of XENPAK's (X2). XENPAK's (X2) must be provided by the same
manufacturer providing the switches for compatibility and optimum performance.
o One 48 10/100/1000 ports fabric enabled module must be installed with DFC card for
o One 48 Gig SFP ports module must be installed and equipped with the required SFPs.
o One 48 10/100/1000 ports fabric enabled module to connect Call Center agent
workstations and IP Phones.
Thanks in Anticipation