1400 Series IOS Command

Unanswered Question
May 5th, 2010
User Badges:

Does anyone know what is the command I can use to show me the signal strength of the antennas during the installation process?

What I have been doing is to do a linktest and then show log to see what happenned.  I think there should be a better way that the screen will update with all the data when there is a change in signals strength.

Thank you.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
dancampb Wed, 05/05/2010 - 07:55
User Badges:
  • Cisco Employee,

If the bridges are associated then you can see the signal strength and SNR under "show dot11 assoc "

vcscadaboy Wed, 05/05/2010 - 08:00
User Badges:

What about before the bridges associated?  I'm trying to aim the antennas and if I can see whenever there is a signal strength that would be good.

Thank you

Actions

This Discussion