05-05-2010 09:07 AM
I have 32 collectors on the same source device monitoring various distributions throughout our enterprise. I set these up approximately a week ago, and am unable to pull any information. They are no the default 60 minute cycle, utilizing UDP jitter. I ensure I select the proper graph settings to coincide with the collector. The statistics on the source switch (via CLI) seem fine...thoughts?
Solved! Go to Solution.
05-09-2010 02:25 PM
While the IP SLA commands exist on earlier code, the feature was not officially supported (i.e. fully committed and tested) before 12.2(40)SE.
05-05-2010 10:17 PM
Exactly what button did you click to get this error? How did you define these collectors in IPM? Are they Historical or Real-time?
05-06-2010 02:41 AM
Good morning Joe,
Thanks for the reply. I clicked on the Graph button after selecting a collector. I defined them using the default UDP jitter settings. The source device is a 3750 and the destination is a 6500, both with responder capabilities. They are historical.
05-06-2010 10:40 PM
If you click the Monitor button instead, do you get any data in the resulting graphs?
05-07-2010 01:55 AM
Yes, data does appear when monitoring real-time via the Monitor button.
05-07-2010 08:55 PM
Post the ipmpoller.log.
05-08-2010 07:28 PM
Joe, I added 31 additional collectors sourced from a different device. Following this configuration modification it seems that all of the collectors are functioning properly. Thoughts on this? Thanks.
05-08-2010 08:11 PM
Perhaps there is a bug on the previous source device where the historical IP SLA data cannot be properly polled. Without more details, I cannot say for certain.
05-08-2010 08:19 PM
The original source is a couple of 3750-12s stacked, running c3750-ipbasek9-mz.122-25.SEE1.
05-08-2010 08:32 PM
IP SLA is not supported on 3K switches prior to 12.2(40)SE.
05-08-2010 08:34 PM
That would explain it :-) I know it actually runs RTR, not SLA, but figured since IPM configured it that it was supported.
05-09-2010 02:25 PM
While the IP SLA commands exist on earlier code, the feature was not officially supported (i.e. fully committed and tested) before 12.2(40)SE.
05-09-2010 02:56 PM
Thanks Joe. I think I'll simply remove the collectors from this source device. You're expertise, as always, is much apprecaited.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: