My QOS class-map is not matching

Unanswered Question
May 5th, 2010

Hi,

I have configured class-map which matches based on access-group

this accessgroup is configured to match one specific host

i created a policymap and add this classmap under this and i specified "drop" action (Just for testing; assuming all the traffic thro the host wll be dropped-Is is correct ???)

Add the service policy command in WAN interface in Input direction (so the download will be affected)

when i verified access-list is matched but not the class-map

Where iam wrong

Any suggestions

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
Jerry Ye Wed, 05/05/2010 - 11:33

Can you post the configuration and a short description of traffic direction.

Regards,

jerry

harisivaji Wed, 05/05/2010 - 13:13

Class-map match-any dropall

match accessgroup MYPC

policy-map MYPOLICY

class dropall    /*earlier i specified same bandwidth value /

drop

Int fa0/1     /*my WAN interface*/

serive policy input MYPOLICY

Ip access-list extended MYPC

10 permit host 10.29.10.10 any

This i did to make sure that QOS which i configured is working fine or not

becuase iam not able to verify (Frankly saying i dont know ) it

Just i want to limit the download speed of this particular pc when he is accessing WAN so i applied in input direction in WAN

In lan interface there is nothing .related to this

Thanks

Hari

Jerry Ye Wed, 05/05/2010 - 13:21

Your ACL is wrong, you are matching the traffic in the wrong direction.

Assuming you mean download from the Internet

Internet -> F0/1 Router -> PC (10.29.10.10)

the ACL should be like the follow

ip access-list extended MYPC

permit ip any host 10.29.10.10

HTH,

jerry

harisivaji Wed, 05/05/2010 - 13:30

My Network is Like this

Internet====[router]====Switch===PC

Yes you are right i will check and

reply  tomorrow

Thanks for your time

Hari

Actions

This Discussion