cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2050
Views
0
Helpful
5
Replies

CM PG Failover/ CTIOS agent Logout

fabien.damien
Level 1
Level 1

Hi All,

would it be possible to prevent CTIOS agent logout on CM PG failover from side A to Side B on ICM 7.5?

Thanks,

5 Replies 5

Hi David,

i have added /LOAD 0 to the configurations parameters of the PG before publishing this post , however agents were still logging out on CM PG failover.

Please check attached screenshot for more details.

thanks,

Let's take a step back are your agents able to log in to either PG?  Also, how long does the failover process actually take?

david

It takes like 40s for the agents to be able to log in again. (buttons enabled on CTIOS). On the NRFU test i realised that active calls get dropped during this event. Another test was run on call manager subscriber: the Call manager service was restarted, and again all agents lost active calls. It seems that CCM is not failing over correctly. Phone to Phone converstations are preserved.

Your advice is appreciated.

Sounds like major issues with the voice network as the call should not drop, time to open up a TAC case you'll have to go through your gateway configs to ensure everything is setup correctly.

david

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: