easy question regarding copy and pasting ASA config

Unanswered Question
May 6th, 2010
User Badges:

Hey there!

If i was to give someone a config to paste into an ASA, i need to know where its going to error out. For instance, where do i put my end statements and config t statements...


i dont want anything to error on the pasting of this config.... Help?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Thu, 05/06/2010 - 12:22
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

accesshollywood2 wrote:


Hey there!

If i was to give someone a config to paste into an ASA, i need to know where its going to error out. For instance, where do i put my end statements and config t statements...


i dont want anything to error on the pasting of this config.... Help?


Copy and paste about 20 lines at a time otherwise it can miss some of the input. Start in config mode and it should be fine.


Jon

John Blakley Thu, 05/06/2010 - 13:32
User Badges:
  • Purple, 4500 points or more

Just to add what Jon said, make sure that the ASAs are identical because of interface differences. You wouldn't be able to paste a config for a 5550 to a 5505 without it erroring out because of the amount and types of interfaces.


HTH,

John

Actions

This Discussion