05-06-2010 12:03 PM - edited 03-11-2019 10:42 AM
Hey there!
If i was to give someone a config to paste into an ASA, i need to know where its going to error out. For instance, where do i put my end statements and config t statements...
i dont want anything to error on the pasting of this config.... Help?
05-06-2010 12:22 PM
accesshollywood2 wrote:
Hey there!
If i was to give someone a config to paste into an ASA, i need to know where its going to error out. For instance, where do i put my end statements and config t statements...
i dont want anything to error on the pasting of this config.... Help?
Copy and paste about 20 lines at a time otherwise it can miss some of the input. Start in config mode and it should be fine.
Jon
05-06-2010 01:32 PM
Just to add what Jon said, make sure that the ASAs are identical because of interface differences. You wouldn't be able to paste a config for a 5550 to a 5505 without it erroring out because of the amount and types of interfaces.
HTH,
John
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: