HI, everyboady,I have a SPA inserted into a SIP-200,the output from console are shown as belows:
SLOT 2: *May 9 04:01:07.659: %SPA_OIR-6-INSCARD: Card inserted in Subslot 0
*May 9 04:01:17.663: %SPA_OIR-3-HW_INIT_TIMEOUT: subslot 2/0
*May 9 04:01:17.675: %SPA_OIR-3-RECOVERY_RELOAD: subslot 2/0: Attempting recovery by reloading SPA
*May 9 04:01:32.891: %SPA_OIR-3-HW_INIT_TIMEOUT: subslot 2/0
*May 9 04:01:32.903: %SPA_OIR-3-RECOVERY_RELOAD: subslot 2/0: Attempting recovery by reloading SPA
I have search from cisco.com and I found it may be a PPD update problem,so I try to update the FPD image.
Router#sh hw-module subslot all
*May 9 04:02:03.335: %SPA_OIR-3-HW_INIT_TIMEOUT: subslot 2/0
*May 9 04:02:03.347: %SPA_OIR-3-RECOVERY_RELOAD: subslot 2/0: Attempting recovery by reloading SPAfpd
==== ====================== ====== =============================================
H/W Field Programmable Current Min. Required
Slot Card Type Ver. Device: "ID-Name" Version Version
==== ====================== ====== ================== =========== ==============
2/0 SPA-2XCT3/DS<DISABLED> 1.2 ???????????? ?.? ?.?
==== ====================== ====== =============================================
Router#upgrade hw-module subslot 2/0 fpd file sip2-disk0:sip2-disk0:c7600-fpd-pkg.122-33.SRB6.pkg
Router#$bslot 2/0 fpd file sip2-disk0:c7600-fpd-pkg.122-33.SRB6.pkg force
% Cannot get FPD version information from SPA-4XCT3/DS0 in subslot 2/0.
No manual upgrade operation can be performed for the target card at this
moment. Try to repeat the operation sometime later.
If the problem persists and the target card is still not in operational
state, then open a case with the Technical Assistance Center via the
Internet at http://www.cisco.com/cgi-bin/front.x/case_tools/caseOpen.pl,
or contact your Cisco technical support representative and provide the
representative with the information that you have gathered.
Attach the following information to your case in non-zipped, plain-text
(.txt) format:
- The console output exactly as it appears after the failure.
- Output of the "show hw-module all fpd", "show logging" and
"show tech-support" commands.
But they provide me information that I cannot update them,
What problems with my SPA ? Anybody can help me ?
Thanks.
