05-10-2010 01:02 AM - edited 07-03-2021 06:47 PM
Hi,
I had updated the AP to lightweight but half way due to power trip.
Now when bootup, the led keep on shows amber-red-green continously.
The AP grab a dhcp ip but unable to browse or telnet.
Please advise.
Solved! Go to Solution.
05-10-2010 03:35 PM
updated the AP to lightweight but half way due to power trip.
Nope. The APs on ROMmon.
the led keep on shows amber-red-green continously
Yup. ROMmon.Here's how you fix it:
And then convert it to LWAP but make sure the power doesn't go either.
Don't forget to rate our useful posts. Thanks.
05-10-2010 06:04 AM
I think the AP is successfuly converted to LWAPP, If yes we cannot access the LWAPP through the telnet or the browser. Lets try consoling into the device and issue the command "show version" if we see W8 in the image then it means its running the LWAPP image and if we hav the controller, then on the AP CLI issue the command "show lwap client rcb" and check to which controller its associated to.. if not associated, it will in a reload loop..
05-10-2010 03:35 PM
updated the AP to lightweight but half way due to power trip.
Nope. The APs on ROMmon.
the led keep on shows amber-red-green continously
Yup. ROMmon.Here's how you fix it:
And then convert it to LWAP but make sure the power doesn't go either.
Don't forget to rate our useful posts. Thanks.
05-11-2010 10:42 PM
Thank you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide