I have switch SRW248G4. And he has issue with load configuration. I loaded firmware but without any result. Please help. I placed below logs from booting device.
------ Performing the Power-On Self Test (POST) ------
Linksys SmartSwitch based on 88E6218 with ARM946E-S. 32MByte SDRAM. I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.
Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom. Preparing to decompress... 100% Decompressing SW from flash 100%
OK Running from RAM...
******************************************************************* *** Running SW Ver. 1.2.1b Date 31-Aug-2006 Time 13:47:21 *** *******************************************************************
HW version is 00.03.00 Base Mac address is: 00:1a:70:2b:f6:58 Dram size is : 32M bytes Dram first block size is : 16969K bytes Dram first PTR is : 0xF6D840 Flash size is: 8M 01-Jan-2000 01:01:02 %CDB-I-LOADCONFIG: Loading startup configuration. 01-Jan-2000 01:01:04 %ERHG-F-SEND: BOXP_perform_smi_scan_of_devices_in_slot - fa iled reading device id on device 0
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
