when i want to configure guard module but some logs displaying. what is the problem and what am i do.
logs below thats;
admin@GUARD#conf terminal
Management module is busy. Please try again in 10 seconds
******************************************************************************
admin@GUARD-conf#interface eth1
admin@GUARD-conf-if-eth1#no sh
admin@GUARD-conf-if-eth1#no shutdown
To complete the configuration change you must reload the software
Are you sure you want to reload? Type 'yes' to reload
yes
reloading...
null
Shutting down interface giga2: [ OK ]
Message from syslogd@localhost at Mon May 10 08:52:05 2010 ...
localhost admin: RHInit FATAL: Bad CFE version ( 34). This version requires version 31 /* what does it mean
Can't connect to managment module; SYSTEM IS NOT FULLY OPERATIONAL: Connection refused
Can't connect to managment module; SYSTEM IS NOT FULLY OPERATIONAL: Connection refused
*******************************************************************************
admin@GUARD#sh running-config
Can't connect to managment module; SYSTEM IS NOT FULLY OPERATIONAL: Connection refused
Can't write to socket
Error getting reactivate-after-reboot information
Management module is busy. Please try again in 10 seconds
Management module is busy. Please try again in 10 seconds
Management module is busy. Please try again in 10 seconds
thanks.