Commands autonomous AP

Unanswered Question
May 10th, 2010

Good afternoon,

I get in touch with you to make you the next question ...
You can set any command in the autonomous AP to send SNMP traps to a server from a client asociaicón recorded in the AP and the disassociation of this, if so which command would have to put ... or would be done with some script, as I say would be to send if a client is associated or has failed in the association ...

Thank you very much
Regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Mon, 05/10/2010 - 16:10

snmp-serv enable traps authenticate-fail
snmp-serv enable traps deauthenticate
snmp-serv enable traps disassociate

druiz@metro Mon, 05/10/2010 - 22:22

Thank you very much for the information, I have been very helpful

Greetings

Leo Laohoo Mon, 05/10/2010 - 22:33

If previous post have answered your question, can you mark it as "Answered"?

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode