CME 7.0 Problems with meet-me "cannot complete conference"

Unanswered Question
May 10th, 2010
User Badges:

Hello !



I have CME 7.0 in 2821 with  c2800nm-adventerprisek9-mz.124-20.T.bin, the following voice cards are included

VIC-4FXS/DID=
VWIC2-1MFT-T1/E1


The E1 card  is configured with just 10 trunks, a PVDM2-48 is includeed



I have been tried to config meet-me but when I dial meet-me number the following message is displayed
"cannot complete conference"


I don´t understand the reason of the message.


I attach the config related with meet-me,


if any of you can help me I would appreciate


regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Walter Solano Thu, 05/20/2010 - 05:23
User Badges:
  • Gold, 750 points or more

Hello,


Have you check if the DSP farm is register with CME?? with the "show sccp all" command you will be able to see that.


HTH

Please rate this post if was helpful


Walter Solano

CCNA Voice

Cisco UCCX Specialist

filiberto.aguirre Thu, 05/20/2010 - 08:11
User Badges:

hi walter,



DSP farm are registered, I attach the results of sh dspfarm all and sh sccp all.


that's why I  don't understand the reason of the message


regards,

iantra123 Tue, 06/29/2010 - 05:49
User Badges:

Try first to remove the command "conference hardware" in the telephony service

Actions

This Discussion