05-10-2010 05:35 PM - edited 03-15-2019 10:42 PM
Hello !
I have CME 7.0 in 2821 with c2800nm-adventerprisek9-mz.124-20.T.bin, the following voice cards are included
VIC-4FXS/DID=
VWIC2-1MFT-T1/E1
The E1 card is configured with just 10 trunks, a PVDM2-48 is includeed
I have been tried to config meet-me but when I dial meet-me number the following message is displayed
"cannot complete conference"
I don´t understand the reason of the message.
I attach the config related with meet-me,
if any of you can help me I would appreciate
regards
05-20-2010 05:23 AM
Hello,
Have you check if the DSP farm is register with CME?? with the "show sccp all" command you will be able to see that.
HTH
Please rate this post if was helpful
Walter Solano
CCNA Voice
Cisco UCCX Specialist
05-20-2010 08:11 AM
06-29-2010 05:49 AM
Try first to remove the command "conference hardware" in the telephony service
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide