i have change uc 520 config-register 0x2101 by mistake

Unanswered Question
David Harper Tue, 05/11/2010 - 02:07

Can you connect to the uc500 now?  Either by telnet/ssh or by console?

If you can telnet/ssh or you connect by console and get a normal IOS prompt, then go into config mode and enter the following command:

config-register 0x2102

Otherwise connect to the console and see if you are getting a rommon> prompt.  If so, enter the commands:

confreg 0x2102


And all should be good.




This Discussion