Router simulating frame relay

Unanswered Question
May 11th, 2010

All,

I'm trying to create a full mesh network, but i keep getting the message of "Can't use same dlci on overlapping circuits"

I create the following from int s1/1 and on the second command I get the above message.

frame-relay route 102 int s1/0 101

frame-relay route 102 int s1/2 100

Can this be done or are my parameters wrong?

Regards,

SM

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
bgandhi Tue, 05/11/2010 - 22:00

Hi Steven,

This is not allowed. You need to map separate DLCI for each interface. You can use 102 for 1 interface but other has to be different, you may use 103.

Regards,

Bhavesh

Calin Chiorean Tue, 05/11/2010 - 23:53

Here is an example:

! very important

frame-relay switching

!

!

interface Serial5/0:1
description TO_R2
no ip address
encapsulation frame-relay
frame-relay intf-type dce
frame-relay route 205 interface Serial5/1:2 502
frame-relay route 207 interface Serial6/0 702
frame-relay route 209 interface Serial6/1 902

As it was specified in the previous post one dlci / route.

Good luck!

smuhle91870 Wed, 05/12/2010 - 05:50

That's what I'm finally figuring out.


Thanks a lot, to both responses.

Actions

This Discussion