Hello
I have the following set up on my network.
My problem is that i cannot get a DHCP address on the client.
I have the following config for both:
Global
#################################
ip dhcp snooping
ip dhcp snooping vlan 10 , 20 , 30
##################################
Interface trunk
#################################
switchport mode trunk
switchport trunk allow vlan 10,20,30
switchport trunk encapsulation dot1q
ip dhcp snooping trurst *only on the Client's switch
#################################
Thank you !
My problem is that i cannot get a DHCP address on the client.
I have the following config for both:
Global
#################################
ip dhcp snooping
ip dhcp snooping vlan 10 , 20 , 30
##################################
Interface trunk
#################################
switchport mode trunk
switchport trunk allow vlan 10,20,30
switchport trunk encapsulation dot1q
ip dhcp snooping trurst *only on the Client's switch
#################################
Thank you !
Hi,
To configure DHCP snooping just follow these steps
The first step to configure DHCP Snooping is to turn on DHCP snooping in all Cisco Switches using the “ip dhcp snooping” command.
All Cisco Switches (config)#ip dhcp snooping
Second step is to configure the trusted interfaces,
Switch(config)#interface range gigabitEthernet 3/21 - 23
Switch (config-if)#ip dhcp snooping trust
Finally configure VLANS for DHCP snooping DHCP snooping will used on all the VLANs
Hope to Help !!
Ganesh.H
