05-12-2010 07:34 AM - edited 02-21-2020 03:57 AM
Hello,
I have a question about a migration NAC Appliance 7.0 version in L2 OOB deployment to L3 Real-IP Gateway.
Do I need any other issue to this or I only must change settings on CAM in "Clean Access Server Type"?
I don't have a lab to test it.
Kamil,
05-12-2010 06:59 PM
Kamil,
Is your L2 OOB deployment Real-IP also? If so, to enable L3, you just have to checkmark the box in the network settings and reboot your CAS. If it's in VGW mode, then a bit more work is required.
HTH,
Faisal
05-13-2010 12:44 AM
Faisal,
This deployment is L2 OOB VG.
The next question is if I changed server type from L2 OOB VG to L2 OOB Real-IP in network setings do I lose some settings in configuration?
What else do I need to do, what you mentioned?
Kamil
05-14-2010 12:45 PM
Kamil,
You'll have to give different IP address to your untrusted interface for one. Going from VGW to RIP is a major design change, so you'll have to vet your design again to ensure that the NAC traffic flow is working the way you expect it to.
HTH,
Faisal
05-17-2010 10:27 AM
Hi Faisal,
What is the procedure for a NAC in HA?
Kamil
05-17-2010 07:24 PM
05-18-2010 12:33 AM
Hi Faisal,
It's a small a misunderstanding about NAC in HA and my question it's no asked precise.
So, what is the procedure migrating NAC in HA mode from L2 VGW to L3 RIP?
Kamil,
05-18-2010 11:57 AM
Kamil,
That would require a major design change in your network - something I guarantee you is not possible to handle in a forum setting :-)
If you have a Cisco account team, engage them, so they can help you get a workable design for L3 RIP.
HTH,
Faisal
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: