password recovery

Unanswered Question
May 12th, 2010
User Badges:

Hi,


I have a swich with redundant sup engine and need to break the enable password of the same.

Is it required to remove the secondary sup engine from the chassis when I reload and put the primary sup engine in rommon mode?

Or will the seconfdary sup active during this process?



Thanks

Richard

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ganesh Hariharan Wed, 05/12/2010 - 22:15
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016

Hi,


I have a swich with redundant sup engine and need to break the enable password of the same.

Is it required to remove the secondary sup engine from the chassis when I reload and put the primary sup engine in rommon mode?

Or will the seconfdary sup active during this process?



Thanks

Richard

Richard,


Remove secondary sup engine


proceed with password recovery for primary Sup engine onece its come up properly insert secondary sup engine for sync config,check out the below link for step by step procedure.


http://www.cisco.com/en/US/products/hw/switches/ps663/products_password_recovery09186a00800945f7.shtml


https://cisco.com/application/pdf/paws/30222/178.pdf


Hope to Help !!


Ganesh.H


Remember to rate the helpful post

Actions

This Discussion