05-13-2010 05:15 AM - edited 03-04-2019 08:28 AM
Hi Pros,
I have a 7604 which I have to configure as Frame Relay Switch. I am able to configure frame-relay switching globally and set the interface as intf-type dce. But I am not able to configure any frame-relay route command under DCE interface. But I am able to execute the show command "show frame-relay route".
7604 running s72033-ipservices_wan-mz.122-18.SXF.bin. I suspected it could be a hidden command but it is not taking the command when executed.
R4-7604-P3-CORE(config-if)#frame
R4-7604-P3-CORE(config-if)#frame-relay ?
accounting Special accounting instruction
broadcast-queue Define a broadcast queue and transmit rate
class Define a map class on the interface
congestion-management Enable Frame Relay congestion management
de-group Associate a DE group with a DLCI
fast-restart fast restart on switchover
fragment Enable end-to-end fragmentation for all PVCs
ifmib-counter64 Support IF-MIB's total packet/byte counts of Counter64
on FR if/subif when main interface's ifSpeed < 20 Mbps
interface-dlci Define a DLCI on an interface/subinterface
intf-type Configure a FR DTE/DCE/NNI interface
inverse-arp Enable/disable FR inverse ARP
ip Frame Relay Internet Protocol config commands
lapf set LAPF parameter
lmi-n391dte set full status polling counter
lmi-n392dce LMI error threshold
lmi-n392dte LMI error threshold
lmi-n393dce set LMI monitored event count
lmi-n393dte set LMI monitored event count
lmi-t392dce set DCE polling verification timer
lmi-type Use CISCO-ANSI-CCITT type LMI
local-dlci Set source DLCI when LMI is not supported
map Map a protocol address to a DLCI address
multicast-dlci Set DLCI of a multicast group
policing Enable Frame Relay policing
priority-dlci-group Define a priority group of DLCIs
svc Enable frame relay SVCs
traps-maximum set max traps FR generates at link up or when getting
LMI Full Status message
vc-bundle configure a frame-relay vc-bundle
R4-7604-P3-CORE(config-if)#frame-relay route 101 inter po 4/0/0 100
^
% Invalid input detected at '^' marker.
05-13-2010 06:01 AM
Hi,
I found the reason for it. Actually there are 2 ways of configuring frame-relay route. One is to configure frame-relay route under the interface config. And the second option is to configure connect statements globally in the router. I missed noticing the second option.
thanks
Arun
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide