CatOS to Cisco IOS Software

Unanswered Question

Hi All


Hopefully somebody will be able to help on this issue I am seeing, I am trying to convert a sup2 running CatOS to IOS using the following link:


http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfa6.shtml#conv_msfc_2


All goes well up to step 15 where I am loading the IOS software but this is where it fails....please see below.

----------------------------------------------------------------------------------------------------------------

Download Completed! Booting the image.
Self decompressing the image :


#############################################################################################################


#################################################################### [OK]


              Restricted Rights Legend


Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.


           cisco Systems, Inc.
           170 West Tasman Drive
           San Jose, California 95134-1706




Cisco Internetwork Operating System Software
IOS (tm) c6sup2_rp Software (c6sup2_rp-JK9SV-M), Version 12.2(18)SXD7b, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by cisco Systems, Inc.
Compiled Fri 08-Dec-06 10:34 by ccai
Image text-base: 0x4002100C, data-base: 0x425D0000



This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.


A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html


If you require further assistance please contact us by sending email to
[email protected].

----------------THIS IS WHERE THE SYSTEM HANGS-----------------------------------------------------------------



I get no output after I see the last line in the above output ([email protected].) as the system is in a Lab and I am remote using the console port, when I go to the lab all lights are off on the Supervisor....


I have attached a print screen of the commands on the Supervisor, I have tried a different IOS and flash card, I have also replaced the MSFC2 on the Supervisor.


Many Thanks MJ

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
robert.horrigan Thu, 05/13/2010 - 11:38
User Badges:

Try reformatting the flashcard, or better yet, use a flash card from a working SUP that's running this image.

craig bache Sat, 05/15/2010 - 00:00
User Badges:

Hi


I thnk there was some kind of memory issue on the card as this is only fail when putting the IOS in to the DRAM.


Regards

Actions

This Discussion

Related Content