In my SPA8000. when I change the "Display Name" (aka: Caller ID name) found under each line configuration (L1, L2, L...etc), when making an outbound call, the Display Name seems not to be working, that is, the "Display Name" I specified (i.e.: 7877992010) is not displayed. All the instructions I have read so far, indicates that I should be able to change the display name (aka: CID) by using the SPA8000 interface.
I followed the instructions found at: http://www.cisco.com/en/US/products/ps10024/products_qanda_item09186a0080a35d2f.shtml
But nothing seems to work.
My goal is that when making outbound calls via the SPA8000 the CID displayed at the recieving end is consistent with the CID name I defined via the Display Name attribute.