05-14-2010 04:32 AM - edited 03-15-2019 10:45 PM
I had the following set up
Phone A 1234
Phone B 2222
Phone A wish to BLF phone B and be able to pickup Phone B when some cone alls 2222. When I tested it on 7.0 I only had to set the Subscribe CSS on Phone A to include the Internal Partition and add DN 2222 as a BLF with the Call Pick up ticked- - All worked However we have re-tested with 7.1.3 and the feature seems to have changed. You now need to create two Pickup Groups A&B and assign DN 2222 to one and associate PUG A to PUG B- very messy. Am I reading the 7.1.3 notes incorrect? Does anyone use BLF with Pickup in 7.1.x
thanks
05-14-2010 05:44 AM
Hi IPT,
Here is a relevant clip
**Note You do not always need to create another call pickup group. A pickup group can have itself as its association group.
CUCM 7.0 notes;
http://www.ciscosystems.cg/en/US/docs/voice_ip_comm/cucm/admin/7_0_1/ccmfeat/fscpickg.html#wp1095877
CUCM 7.1 notes;
http://www.ciscosystems.lt/en/US/docs/voice_ip_comm/cucm/admin/7_1_2/ccmfeat/fscpickg.html#wp1124599
Cheers!
Huff
Please support CSC Helps Haiti
05-14-2010 06:21 AM
Hi Rob,
thanks for the reply I`ve seen the docs but I`m sure I did not have the do a PUG before
05-14-2010 07:21 AM
Hi IPT,
It's been the same since BLF Pickup was introduced in CUCM 6.1(2)
http://www.cisco.mn/en/US/docs/voice_ip_comm/cucmbe/rel_notes/6_1_2/cucmbe-rel_note-612_2.pdf
Cheers!
Huff
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide