Cisco 867 Switch mode only?

Unanswered Question
May 16th, 2010


Is it possible on a Cisco 867 to configre each port individualy, or only by using Vlan's? Everytime I try to assign a IP to an individual port I get the message: 'IP Address may not be configured on L2 links'. I have tried the following:

# Config Term

#(C) Interface FastEthernet0

#(C-if) no switch access Vlan 1

#(C-if) ip address

'IP Address may not be configured on L2 links FastEthernet0


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Leo Laohoo Sun, 05/16/2010 - 03:53

Errr ... What are you trying to achieve?  The Cisco 867 is a 4-port (layer 2 only) switch with an ADSL/ADSL2+ WAN variety.


This Discussion