Blade Server/Switch Question

Unanswered Question
May 16th, 2010

Hi -- a bit confused about something.

If a blade chassis/encosure is going to use the Cisco 3130 blade switch, where does it fit into the overall architecture of the enclosure?

For example, the Dell M-1000e blade enclosure was designed to support Ciscos 3130 blade switches. But how do they fit into the overall architecture  scheme? Normally, the blade servers connect to the I/O fabrics through the passive where does the switch come in? Or does the switch replace the I/O fabrics?



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion