CAT 6500 - WS_SUP32GE-3B redundancy quetion.

Unanswered Question
May 16th, 2010

Currently we only have one WS-SUP32GE-3B module in slot 5 of out CAT 6500. We have just purchased a second one to put in slot 6.

Currently the module in slot 5 has the following config:

redundancy
keepalive-enable
mode sso
main-cpu
  auto-sync running-config

Once I prepare the new module to run the same IOS version as the existing module in slot 5 and during a maintenance window put the new module in slot 6, with the above config, then the config should sync from the Active module in slot 5 to the Standby modulein slot 6 - right?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 2 (1 ratings)
Loading.
Ganesh Hariharan Sun, 05/16/2010 - 23:02

Currently we only have one WS-SUP32GE-3B module in slot 5 of out CAT 6500. We have just purchased a second one to put in slot 6.

Currently the module in slot 5 has the following config:

redundancy
keepalive-enable
mode sso
main-cpu
  auto-sync running-config

Once I prepare the new module to run the same IOS version as the existing module in slot 5 and during a maintenance window put the new module in slot 6, with the above config, then the config should sync from the Active module in slot 5 to the Standby modulein slot 6 - right?

Hi,

Check out the below link for step by step procedure for adding new sup in 6500

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008085a6d3.shtml#concept1

Hope to help !!

Ganesh.H

If helpful do rate the post

Actions

This Discussion

Related Content