WCS and WLC syncing

Unanswered Question
May 16th, 2010

Gday again,

I am converting standalone cisco1231AP to LWAPP. In the process, the conversion is always successfull. Run the audit on WCS, refresh values from Controller and restore values from Controller... The process after that involves us running few lightweight templates. Now, with the newly converted AP, I used to be able to see thm on both WCS and WLC. However, I dont see the new APs in WLC anymore. Besides checking the SNMP settings for sync, what else should I check?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Surendra BG Mon, 05/31/2010 - 08:39

are the APs registered to the WLC? whats the software running on the WLC and WCS??


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode