Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
585
Views
0
Helpful
2
Replies

SMNP trap remove for 2 modules

obrien2010
Level 1
Level 1

‎05-17-2010 05:24 AM

I have removed 2 modules from my 6509 switch, 1 and 2.  How do I disable the ttraps for just those 2

mods without disabling it for all modules?

Labels:
0 Helpful
2 Replies 2

David Stanford
Cisco Employee
Cisco Employee

‎05-17-2010 05:47 AM

Are you trying to disable envmon or fru type traps or all traps related to these modules?

SNMP traps are usually global commands, which means they impact all modules/interfaces on a device. If the module isn't there, then traps won't be generated for it.

0 Helpful

obrien2010
Level 1
Level 1
In response to David Stanford

‎05-17-2010 07:59 AM

I think I got it.  The switch generated a trap

when the 2 mods were removed.  My net mon software (Spectrum) pick

ed it up after I removed from maintenance.  Must have been buffered in there.  You are quite correct.  It was only a global command.

Thanks!!

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents